#1 2007-05-16 02:08:07
- wsr
- GI-Joe
- Registered: 2007-04-08
- Posts: 18
Stucked with Pattern 5.
Scrolled through the forum and I didn't see any or solution or if any had any clue what is causing it.
I'm talking about that Pattern 5 in group B gets stucked in monosynth upon midi sync with Dtronics interface.
I bougt the interface from dtronic some weeks ago so It's new, I'm not sure but it seems like the older interfaces might not have this problem.
Offline
#2 2007-05-16 08:54:10
- jbuonacc
- Centipede
- From: Rochester, NY usa
- Registered: 2007-02-07
- Posts: 447
Re: Stucked with Pattern 5.
this may have already been discussed a bit. were you on that pattern before sync, or did it jump to it and stay? have you tried sending a Program Change message?
Offline
#3 2007-05-16 09:55:37
- tuluseabaska
- Dan Dare
- From: warsaw
- Registered: 2006-07-10
- Posts: 77
Re: Stucked with Pattern 5.
I've mentioned this here: http://www.prophet64-forum.com/viewtopic.php?id=575
Offline
#4 2007-05-16 10:18:25
- MikeTorino
- Guest
Re: Stucked with Pattern 5.
I just found this in the Sequencer manual, page 35:
Be aware of that sending pattern selects will lock up the other edition's pattern until its synchronization mode is switched back to internal clock.
Could it be that the dtronics interface "locks up" and keeps sending the pattern select command...?
#5 2007-05-16 15:07:31
- wsr
- GI-Joe
- Registered: 2007-04-08
- Posts: 18
Re: Stucked with Pattern 5.
"the other edition's" ?
Offline
#6 2007-05-16 15:40:12
- MikeTorino
- Guest
Re: Stucked with Pattern 5.
That's from the Sequencer manual. You can send pattern select commands to other Prophet64 applications from the Sequencer, "the other edition" refers to either Monosynth, Bassline or Drummer.
Board footer
Powered by 
© Copyright 2002–2008