PROPHET64 & MSSIAH Userforum




Official information and support forum for
MSSIAH and all PROPHET64 versions.



You are not logged in.

#1 2010-09-01 23:47:08

Musssid
Rockford
Registered: 2010-02-11
Posts: 54

ive blown another sid

just connected an audio cable to the output of sid2 and tested sound through it ok. i noticed that there was a loose connection as it crackled when i moved the cable
so i used the glue gun to secure the base of the wire

when i tested the sound again all i could here was a humming sound and sid2 felt very hot! so i assume sid2 is blown from when the cable moved.

i put another good sid in but there is no sound at all now

i assume that ive blown a resistor or cap, which resistor and capacitor are effected by sid2?

thanks in advance

Offline

 

Board footer

Powered by
© Copyright 2002–2008