PROPHET64 & MSSIAH Userforum

Official information and support forum for
MSSIAH and all PROPHET64 versions.

You are not logged in.

#1 2009-09-21 15:09:16

Bloody beginner
Registered: 2009-04-29
Posts: 2

Midi Mode Release Problem Help

When in midi mode on monosynth only oscillator A observes the release setting. Notes in Oscillator b stop when i take my finger of the key or when the note message ends. So I'll have a nice decay on oscillator a but b just stops abruptly. I tried my cart in two units and it does the same. Is this a problem with the cart or do i need to filter the midi info i'm sending. It happens when i connect directly with a midi controller keyboard or when i send midi from protools or ableton. Bit time pain in the hole. Two sids installled. Could it be something to do with this. I didn't do the build. I'm new to this so would appreciate any insights into this problem.




Board footer

Powered by
© Copyright 2002–2008