#1 2008-12-08 22:37:14
- klx300r
- Nibbler
- Registered: 2007-05-31
- Posts: 42
very long delay when opening sequencer??
well finally got my MSSIAH cart today and of course was all excited once I came back from the post office and all BUT I am a bit worried about a VERY long delay(timed at 1min46 seconds) when I load up sequencer?? unplugged the mouse, reseated the cart, booted up again and same situation??
now the program works fine once its starts but WTF??? my P64 never had this issue....this happening to anyone else?
Last edited by klx300r (2008-12-08 22:37:41)
Offline
#2 2008-12-08 22:53:56
- kingconga42
- Bomb Jack
- From: US and A
- Registered: 2007-10-16
- Posts: 32
- Website
Re: very long delay when opening sequencer??
That is way too long. The manual says 10 second load time, which is what i get. I dunno?
= burnkit2600.com =
Offline
#3 2008-12-09 21:53:08
- klx300r
- Nibbler
- Registered: 2007-05-31
- Posts: 42
Re: very long delay when opening sequencer??
ok problem solved by removing a reset switch I had installed in the serial port...works great with standard 10 second delay now :-)
Offline
#4 2009-01-04 13:40:01
- Flemming
- The Last Ninja
- Registered: 2008-11-27
- Posts: 291
Re: very long delay when opening sequencer??
klx300r wrote:
ok problem solved by removing a reset switch I had installed in the serial port...works great with standard 10 second delay now :-)
Supernice 
may i ask.. was the reset-button internal or external (like plugged into the serialport or soldered on the inside)???
You can always do the good old reset-switch using pin 1 and 3 of the user-port it does not interfere with MSSIAH loading!
Offline
Board footer
Powered by 
© Copyright 2002–2008