#1 2014-03-30 21:37:55
- Vectro
- Bloody beginner
- Registered: 2013-04-04
- Posts: 2
What is the best way to connect PSONE-display without any soldering
Hi all,
I was browsing through the previous conversation concerning PSOne display and C64. I would like to connect the display without any soldering if possible.
I managed to find original C64 cable with 8-pin DIN to 3 x RCA (white, yellow and red). I then connected the cable with 6,3mm to 3,2mm adapter to the PSOne input. --> no image or signal:
Below you can see the first cable setup that I tried:
http://lentosimulaattori.1g.fi/kuvat/PSONE/IMG_0302.JPG
I also managed to find old Playstation 3 cable that seems to fit the PSOne display input. This setup didn't work either (no image in the display):
http://lentosimulaattori.1g.fi/kuvat/PSONE/IMG_0303.JPG
C64DIN -> RCA -> PS connector
So, do I need some kind of signal converter,adapter, etc. or am I just connecting the setup wrong way now?
Kind regards and thanks for your help in advance,
BR,
OP
Last edited by Vectro (2014-03-30 21:56:32)
Offline
#2 2014-03-31 08:01:01
- Vectro
- Bloody beginner
- Registered: 2013-04-04
- Posts: 2
Re: What is the best way to connect PSONE-display without any soldering
Just learned that you'll need RCA to TRSS adapter cord instead of normal stereo mini jack to PSOne.
So, hopefully this compination will do the job:
C64 8-pin DIN video OUT -> RCA (white, red, yellow) -> RCA male to male adapter -> RCA to TRSS cord -> PSOne input:
http://deepsurplus.com/Home-Theater-Aud … -Cable-6ft
Offline
Board footer
Powered by 
© Copyright 2002–2008