PROPHET64 & MSSIAH Userforum




Official information and support forum for
MSSIAH and all PROPHET64 versions.



You are not logged in.

#1 2012-11-08 17:35:01

MadModder
Bomb Jack
Registered: 2012-11-03
Posts: 31

Modified SID2SID

I ordered a SID2SID board the other week.
After reading thread after thread about getting rid of as much noise as possible, I thought why not ditch the motherboard audio circuitry completely?
I have bought a bag of ultra low noise transistors for audio, and are going to copy the audio output stage on the SID2SID board to the right side, and also have onboard capacitors for audio in. Then use shielded cable for routing the audio signals to pots and connectors. And also filter the voltages to the SID better.
At least that idea sounds good in my head... smile

I will make my own PCB, and (eventually) write an article about the mod on my web page.
However, I then thought about copyright and all that.
Am I allowed to present the modified SID2SID-based PCB layout on my page, or not?

Offline

 

#2 2012-11-11 12:19:40

InactiveX
The Last Ninja
From: England
Registered: 2008-08-14
Posts: 280

Re: Modified SID2SID

I think as long as you're posting up a diagram, and not selling anything, then you should be fine.

Might be nice to give credit where due.

Offline

 

Board footer

Powered by
© Copyright 2002–2008