PROPHET64 & MSSIAH Userforum




Official information and support forum for
MSSIAH and all PROPHET64 versions.



You are not logged in.

#1 2009-05-10 13:43:44

nusse
GI-Joe
From: Stockholm
Registered: 2008-09-20
Posts: 19

Pattern Select questions.

I wanna use the sequenser and pattern select in the MSSIAH and send it to another c64 with the P64 bassline running.

The manual for the 24-64 sync converter shows 5 output lines for the pattern select (plus one for the ground) , ive already have the input and output on my converters(5 Pin Female connectors). I suppose this means that i have to solder another "output" for the pattern select, just solder a 6pin DIN connector.

But the question is , should i connect the pattern select cable to Sync In on the P64 , or is there a special input for the pattern select?
Either way i have to modify my converters with 6 pin connectors.

Sorry for bad English

Last edited by nusse (2009-05-10 21:22:44)

Offline

 

#2 2009-05-15 14:45:39

nusse
GI-Joe
From: Stockholm
Registered: 2008-09-20
Posts: 19

Re: Pattern Select questions.

Anyone?

Sombody must have tried the sequencer with pattern select!

Offline

 

#3 2011-10-25 02:47:04

Ganjoe_Rood
Bomb Jack
From: Berlin
Registered: 2006-07-10
Posts: 34

Re: Pattern Select questions.

this question came yet to my mind. i guess the feature was never implemented or documented.

Offline

 

Board footer

Powered by
© Copyright 2002–2008